Reception desk – day 8
I am down to one thing left to do on the desk and that is the polyurethane finish. I really don’t have the room to set up the spray booth … Continue reading
Reception desk – day 7
I wrapped up construction yesterday, but I didn’t get a chance to put up a post. So todays post has two days of effort. The final big item on my … Continue reading
Reception desk – day 6
Since I have large round-overs around the counter top, My T-square jig won’t work the same as it did for the shelves. I won’t be able to line up the … Continue reading
Reception desk – day 5
Yesterday’s panels are cured, so I ran them through the planer, taking them down to 3/4″ thick. I ran all of the boards through the table saw to take them … Continue reading
Reception desk – day 4
I have decided to work on the upper portion of the desk next. For the counter top, I want to use a solid piece of 6/4 oak. For this, I … Continue reading
Reception desk – day 3
Well I managed to sneak in a few hours of shop time this weekend around Rob’s wedding. Enough time to finish the counter top anyway. I realized that I forgot … Continue reading
Reception desk – day 2
So it is shaping up to be a busier week than I planned. I did have some time last night to start on the counter top. I started by wrestling … Continue reading
Reception desk – day 1
I haven’t had much time in the shop over the last couple of weeks, but I put some time in today. I am starting on a two-level reception desk for … Continue reading
Statue bases – day 8
My intent was to spray a third coat today, but after checking on the dry bases, I determined that were actually pretty good. The finish was smooth and even, and … Continue reading
Statue bases – day 7
Before I apply the second coat of poly, I need to sand down the finish to remove any raised grain or dust nibs that settled on the boxes while they … Continue reading
Statue bases – day 6
The stain has set for two days, and I had a few minutes, this evening, to get the first coat of polyurethane on. If I was brushing on the poly, … Continue reading
Statue bases – day 5
I had a few minutes last night to get the stain on my statue bases. I noticed that a lot of dust had settled over night, so I ran the shop-vac … Continue reading
Statue bases – day 4
To save myself a lot of tedious detail sanding later, I decided to sand down all of the base cap trim, before installing it. I cut all of my trim … Continue reading
Statue bases – day 3
Before installing the base trim on the boxes, I need to install the bottom spacers. I once again turned to my pile of off-cuts for some 20″ long pieces that … Continue reading
Statue bases – day 2
My plan for today was to get the profiles cut out for the three-layer base trim, for the boxes. My next project will be a reception desk that will have … Continue reading
Statue bases – day 1
I haven’t been in the shop much this past month or so. Even though my shop is nicely heated, I just kind of got a bit lazy this time of year. Perhaps … Continue reading
12′ Cherry Conference room table – delivered
No rain today, so I packed up the table into my old Dodge and headed to church. I took my older son and put him and Father Jason to work, … Continue reading
12′ Cherry Conference room table – day 8
I applied the first two coats of wipe-on poly yesterday, so I added the last two coats today. Most of the surfaces were vertical, so very little dust landed on the urethane … Continue reading
12′ Cherry Conference room table – day 7
Another long day today, but I made a lot of progress. I started today by cutting away the excess trim and dowels sticking past the trim on the tops. Next … Continue reading
12′ Cherry Conference room table – day 6
The base is done, so I decided to work on making the table top today. I might be going a bit overboard, but I want the top to be strong … Continue reading
Midnight Woodworking 