Steve’s custom baritone
I had the opportunity recently to work on another guitar with my friend Steve. He had some ash boards that were reclaimed from a previous project and he wanted to … Continue reading
Baritone rebuild – day 8 complete
The finish is cured, so my last step is to apply a coat of paste wax. I let it set for a few minutes, then I rubbed it off with … Continue reading
Baritone rebuild – day 7
Bill finally got me the last piece of the project today. He wanted this particular style of input jack. I wish I had this component before I carved the rear. I … Continue reading
Baritone rebuild – day 6
I talked to Bill about the switch and he didn’t feel like looking for one with a longer neck, so before I put on another coat of oil, I need … Continue reading
Baritone rebuild – day 5
I had a lot of details to tidy up before starting to apply the finish today. I started by pulling the clamps off the headstock veneer, then taping off the … Continue reading
Baritone rebuild – day 4
With the body roughly sanded, it is time to round over the top and bottom edges. I used a 1/4″ round-over bit in my little Bosch Colt. Just a quick … Continue reading
Baritone rebuild – day 3
Ok, so I had every intention of finishing the body last weekend, but I ran into a lot of operator error, mixed with a little bit of trouble from my … Continue reading
Baritone rebuild – day 2
Interesting day today. I started early by loading the second walnut panel into the CNC and started the top half of the guitar carving. Then I unwrapped the book-matched set … Continue reading
Baritone rebuild – day 1
My friend Bill has another guitar for me to rebuild. The last one was the Jerry Jones Baby Sitar. This one is also a Jerry jones, but it is a … Continue reading