Tabernacle build – day 13
I put the third coat of poly on early this morning so I would have time for one more today. Before applying the fourth coat, I sanded the entire thing … Continue reading
Tabernacle build – day 12
Well, the stain has had about 12 hours to dry, and the can says a minimum of 8, so I should be good to start applying the finish. All of … Continue reading
Tabernacle build – day 11
After pulling the clamps off of the glued up door panel, I used my smallest chisel to mortise out the area where the pivot on the knife hinge sits. I … Continue reading
Tabernacle build – day 10
I worked on the door panel last night. I don’t actually have a complete plan for what it will ultimately look like when completed, just a vague notion of what … Continue reading
Tabernacle build – day 9
After sanding the columns and their banding to match the cabinet body, I applied glue to the first column and clamped it in place. Since the first one attached … Continue reading
Tabernacle build – day 8
Today I spent several hours working on the banding for the columns. Yesterday, I set up a sacrificial work table and fence on my 12″ miter saw. This tool is … Continue reading
Tabernacle build – day 7
The new upper base is dry and marked, so I cut the circle out on the bandsaw. I sanded the edges on the spindle sander, taking the edge down to … Continue reading
Tabernacle build – day 6
I only had a couple of hours to work this evening, so I took care of some small things. I measured and cut the spacers for the hidden door plate. … Continue reading
Tabernacle build – day 5
I started the day trying to figure out what to do with the ugly inside of the dome. I didn’t feel comfortable trying to turn the inside. With the outside … Continue reading
Tabernacle build – day 4
I pulled the clamps on the dome and started making a cross-brace to go across the bottom. Since the bottom flange will not be getting much smaller, I used pocket … Continue reading