Reclaimed reverse Firebird – day 6
I applied the fourth and fifth coats of oil yesterday, so this morning I applied a coat of paste wax to the body, rubbing it in with a soft cloth. … Continue reading
Reclaimed reverse Firebird – day 5
I managed to get two additional coats of Tung oil applied today. Between each coat, I sand down the entire body with 400 grit paper. After a liberal coating of … Continue reading
Reclaimed reverse Firebird – day 4
I want to attach the control cavity cover with magnets. I made sure to place matching pilot holes in the cavity and on the cover. Since I drilled 1/8″ holes … Continue reading
Reclaimed reverse Firebird – day 3
I had an early Dentist appointment yesterday, so I used the excuse to blow off the entire day from work. An unplanned day off typically means a day in the … Continue reading
Reclaimed reverse Firebird – day 2
After the dye had cured on my front and rear panels, I loaded the first board into my Carvewright CNC and started the first panel. The back side ran just … Continue reading
Reclaimed reverse Firebird – day 1
My oldest son, Eric, is going back to college in a couple of weeks and he is planning on taking guitar lessons this semester. I offered to build him a … Continue reading
Another 72 thinline telecaster – day 3
I was getting ready to glue up the two halves of the guitar when I noticed a small problem. The pilot holes for the neck screws were off on the … Continue reading
Another 72 thinline telecaster – day 2
The second half finished its run in the carver. I flipped it over and cut away the tabs. With both halves freed up, I assembled them in a dry-fit … Continue reading
Another 72 thinline telecaster – day 1
I built a 72 thinline telecaster a few months back, and I have had a request for another one. The first one was made for a friend of mine and … Continue reading
72 thinline telecaster guitar carve – day 3
The glue has dried, so I pulled the clamps. I set the larger spindle up in the spindle sander and sanded all of the larger curves. I stepped sown to … Continue reading
72 thinline telecaster guitar carve – day 2
Spent the day packing my oldest up and taking him back to college. I did squeeze in a bit of time to get back to the guitar body, that I … Continue reading
72 thinline telecaster guitar carve
I had a request for another guitar body. This one is a little different from the solid body guitars that I have built before. This guitar body is modeled after … Continue reading