Midnight Woodworking

Woodworking

Tag Archives: CNC carving a guitar

Another 72 thinline telecaster – day 3

I was getting ready to glue up the two halves of the guitar when I noticed a small problem. The pilot holes for the neck screws were off on the … Continue reading →

February 5, 2015 · Leave a comment

Another 72 thinline telecaster – day 2

  The second half finished its run in the carver. I flipped it over and cut away the tabs. With both halves freed up, I assembled them in a dry-fit … Continue reading →

February 4, 2015 · Leave a comment

Another 72 thinline telecaster – day 1

I built a 72 thinline telecaster a few months back, and I have had a request for another one. The first one was made for a friend of mine and … Continue reading →

February 2, 2015 · 1 Comment

Headless guitar concept – day 4 complete

I gave the body of the guitar, and all the wooden hardware, four coats of low-gloss Tung oil, then let it sit for 24 hours. Yesterday morning I applied a … Continue reading →

September 4, 2014 · 1 Comment

Headless guitar concept – day 3

Third day into this build, and I will have all the parts done today. My focus today was to get all the trim pieces done. I started with the cover for … Continue reading →

September 2, 2014 · Leave a comment

Headless guitar concept – day 2

I had a few little details to accomplish today, before glueing up the front and back halves of the guitar body. Yesterday’s epoxy has dried, so I sanded it down … Continue reading →

September 1, 2014 · Leave a comment

Headless guitar concept – day 1

So I don’t play guitar, but I really enjoy building them. I have been collecting bits and pieces while building other guitars, and I have been kicking around the idea … Continue reading →

August 31, 2014 · Leave a comment

72 thinline telecaster guitar carve – day 3

The glue has dried, so I pulled the clamps. I set the larger spindle up in the spindle sander and sanded all of the larger curves. I stepped sown to … Continue reading →

August 25, 2014 · Leave a comment

72 thinline telecaster guitar carve – day 2

Spent the day packing my oldest up and taking him back to college. I did squeeze in a bit of time to get back to the guitar body, that I … Continue reading →

August 24, 2014 · Leave a comment

72 thinline telecaster guitar carve

I had a request for another guitar body. This one is a little different from the solid body guitars that I have built before.  This guitar body is modeled after … Continue reading →

August 11, 2014 · 1 Comment

Number of visitors

  • 373,160 hits

Follow Blog via Email

Enter your email address to follow this blog and receive notifications of new posts by email.

Join 196 other subscribers

Browse by catagory

Browse my archive