St. Kilian chapel – Ambry – part 4
Stain is dry so I set up the spray booth and got prepped for finish. I set up my knock-down workbench to hold everything and put it all up on … Continue reading
St. Kilian chapel – Ambry – part 3
To fit the door into place, I first had to measure the width of the piano hinge, then subtract a bit more to allow the door a bit of room … Continue reading
St. Kilian chapel – Credence table – part 4 & Gift table part 2
So the credence table and gift table are stained and ready for finish. Normally, I throw up my temporary spray booth and spray, covering two days worth of work in … Continue reading
St. Kilian chapel – Credence table – part 3
Columns are trimmed and all the pieces are milled so it is time to start assembling everything. The most accurate way that I have found to attach the caps and … Continue reading
St. Kilian chapel – Gift table – part 1
I was planning on working on the credence table this weekend, but when I started on the design, it did not seem like it would look right. Originally we had … Continue reading
St. Kilian chapel – Ambo, part 6
Before I sprayed on the polyurethane finish, I flipped the ambo over and brushed two coats of polyurethane on the bottom of the base. I also applied two coats to … Continue reading
St. Kilian chapel – Ambo, part 5
Time for final assembly. I am starting with the top plate. I inserted the first one into the locating jig and spread a thin layer of glue to the top … Continue reading
Church Altar and tabernacle stand – day 26
I finished the last bit of assembly today. I needed to attach the top plates for the raised panels. I used the drill bit from my Kreg pocket hole jig … Continue reading