Midnight Woodworking

Woodworking

Tag Archives: tung oil finish

Coin display – day 1

A friend of mine asked me to make her a coin display, that she can give to her husband for Christmas. He travels a lot and collects coins from each … Continue reading →

December 13, 2013 · Leave a comment

Adam’s piggy bank – day 3

While Adam was finishing up his schoolwork today, I prepped his piggy bank for finishing. I decided to put walnut plugs in the eye and nose holes. I found a … Continue reading →

October 22, 2013 · Leave a comment

Finishing the last supper

I want to start finishing the carving today, but first I need to figure out the mounting. The relief should be able to hang on the wall, or stand on … Continue reading →

October 9, 2013 · Leave a comment

AJ’s custom Stratocaster – day 10

I applied the final (sixth) coat of Tung oil last night. I took a few pictures to hopefully show how the finish turned out. There is also a shot with … Continue reading →

June 13, 2013 · Leave a comment

AJ’s custom Stratocaster – day 9

As I was getting ready to apply the fifth coat of Tung oil this evening, I paid close attention to the feel of the finish. It was a little rougher … Continue reading →

June 11, 2013 · 1 Comment

AJ’s custom Stratocaster – day 8

The first coat of tung oil has dried. It soaks in pretty deep, so you don’t get much of a shine until the third or fourth coat. Since the finish … Continue reading →

June 10, 2013 · Leave a comment

AJ’s custom Stratocaster – day 7

I wanted to finish the guitar, but I don’t have all the purchased components yet. The main item I need now is the neck. I have an Ibanez neck that … Continue reading →

June 8, 2013 · Leave a comment

More pub chairs – day 14

I am applying the second coat this evening. The chairs have dried from the first coat and there aren’t many dust nibs. The tung oil finish went on pretty smooth. … Continue reading →

May 17, 2013 · Leave a comment

More pub chairs – day 13

I finished up the assembly of the second pub chair of this set last night. I decided to go ahead and apply the first coat of tung oil. I should … Continue reading →

May 17, 2013 · 1 Comment

Pub chairs – day ten

Just a quick post today. I finished two more coats yesterday and one this evening. The pictures are all going to start looking the same at this point… I did … Continue reading →

April 22, 2013 · Leave a comment

Pub chairs – day nine

I had a chance to start finishing the chair last night so I applied the first coat of Tung oil. I decided to use tung oil because it a wipe-on … Continue reading →

April 21, 2013 · Leave a comment

Number of visitors

  • 373,160 hits

Follow Blog via Email

Enter your email address to follow this blog and receive notifications of new posts by email.

Join 196 other subscribers

Browse by catagory

Browse my archive