Midnight Woodworking

Woodworking

Tag Archives: finishing

Finishing party

Just a quick post today. Adam and I both had some finishing to do, so we took a bit of time just before he had to go to bed. Adam … Continue reading

October 23, 2013 · Leave a comment

Church Altar and tabernacle stand – day 29

The wiping poly dries pretty quickly, especially when it was the first coat. I was able to squee an extra brush coat on the two tops last night. This morning, … Continue reading

September 27, 2013 · Leave a comment

Church Altar and tabernacle stand – day 28

Just a quick post this evening. I sanded down all the surfaces that were urethaned yesterday. They did not need much because not much dust settled on altar parts. The … Continue reading

September 26, 2013 · Leave a comment

Church Altar and tabernacle stand – day 27

The thing I like the least about a project is the finishing. I decided to go with a wipe-on Polyurethane finish for this project. To create a wipe-on ploy, you … Continue reading

September 26, 2013 · Leave a comment

Pub chairs – day ten

Just a quick post today. I finished two more coats yesterday and one this evening. The pictures are all going to start looking the same at this point… I did … Continue reading

April 22, 2013 · Leave a comment

Pub chairs – day nine

I had a chance to start finishing the chair last night so I applied the first coat of Tung oil. I decided to use tung oil because it a wipe-on … Continue reading

April 21, 2013 · Leave a comment

Ironing board storage cabinet – day 10

I had a couple of hours to work last night so I drilled the last three pocket holes for the top. I glued it as well as screwing it down. … Continue reading

April 5, 2013 · Leave a comment

Shadow box – day 4

This is a small project, so it is easy to clean up. I decided to go back to steel wool to rough up the first coat of urethane. I like … Continue reading

March 13, 2013 · Leave a comment

Shadow box – day 3

Well, I hadn’t really planned how the glass would be held in place yet. After thinking about it for a bit, I decided to route a 1/8″ groove down the … Continue reading

March 12, 2013 · Leave a comment

Dining room bench build – day four

I am trying a new approach with my finish on this project. I normally just brush on two coats of semi-gloss polyurethane, but I recently watched a video, by Tom … Continue reading

March 5, 2013 · 4 Comments

Number of visitors

  • 168,953 hits

Enter your email address to follow this blog and receive notifications of new posts by email.

Join 101 other followers

Browse by catagory

Browse my archive