We knocked out most of the remaining work on the sofa table last night.
First thing was to notch the tenons on the apron. We clamped all the sides together and set the table saw blade to 3/8″ deep to make the shoulder cut.
Then Rob cut the remaining side on the band saw.
We used a chisel to clean up the shoulder, then did a dry-fit assembly of the carcass.
Everything fit together well, so Rob moved on to sanding the outside faces to remove any scratches or pencil marks.
While he was doing that, I did the same thing on the legs, but with the smoothing plane. since the legs were narrow, the orbital sander may roll over the sides of the legs, rounding them slightly. I figured the plane would leave a crisper edge. That done, I knocked off the sharp edge with a few passes of the block plane.
With the legs and sides cleaned up, Rob applied wood glue to the tenons and we started clamping everything up, long sides first.
When we clamped the sides to the faces, we placed a few of the drawer rails in the middle to keep everything from bowing inward, if clamped too tightly.
With the carcass drying, we moved on to the drawers. Rob applied glue to the small tenons on the front and back pieces, then we clamped them up.
With all the drawers clamped, I checked them for square. One was out of square, so I threw a clamp across two corners and tightened till it was corrected.
The last piece to cut out was the top. We ripped the sides down to the correct width, and Rob cut the board to length.
Rob then cleaned up the edges with my smoothing plane to remove any burn marks from the table saw.
He then added a 1/4″ round-over to match the drawer fronts, and sanded the top.
While he was doing that, I set the drawer bottoms in place, as well as the cross pieces in the carcass. They will all have to be tacked in place later, but it was getting close to midnight and we wanted to put it all together to see how it looked.
Rob was tired, but happy with the finished product.
Looks like there is a bit more sanding and a couple of brad nails to add, then we will be ready for finishing.