Midnight Woodworking

Woodworking

Tag Archives: Walnut and mahogany guitar

Kyle’s Guitar – day 6 – complete

After four coats of High-gloss Tung oil, the guitar is looking good. Time to move on to the installation of the hardware. I measured the output jack, and drilled a … Continue reading →

April 5, 2019 · Leave a comment

Kyle’s Guitar – day 4/5

  I cut some more walnut to make a new back panel. I took care to try to match the sap wood on the front half. It won’t be a … Continue reading →

March 24, 2019 · Leave a comment

Kyle’s Guitar – day 3

While the back panel was curing, I loaded the front panel into my CNC and started the carve. About 4 hours later it finished. Unfortunately the board was slightly thicker … Continue reading →

March 19, 2019 · Leave a comment

Kyle’s Guitar – day 2

Kyle gave me the neck and hardware, that he bought for the guitar, so that I could get exact measurements. Then I drew everything up and did a test carve. … Continue reading →

March 9, 2019 · Leave a comment

Kyle’s Guitar – day 1

My friend Kyle recently asked if I would be interested in helping him build a custom guitar. He had some wood from his Grandfather’s farm that had been cut into … Continue reading →

March 9, 2019 · Leave a comment

Number of visitors

  • 373,160 hits

Follow Blog via Email

Enter your email address to follow this blog and receive notifications of new posts by email.

Join 196 other subscribers

Browse by catagory

Browse my archive