Kyle’s Guitar – day 6 – complete
After four coats of High-gloss Tung oil, the guitar is looking good. Time to move on to the installation of the hardware. I measured the output jack, and drilled a … Continue reading
Kyle’s Guitar – day 4/5
I cut some more walnut to make a new back panel. I took care to try to match the sap wood on the front half. It won’t be a … Continue reading
Kyle’s Guitar – day 3
While the back panel was curing, I loaded the front panel into my CNC and started the carve. About 4 hours later it finished. Unfortunately the board was slightly thicker … Continue reading
Kyle’s Guitar – day 2
Kyle gave me the neck and hardware, that he bought for the guitar, so that I could get exact measurements. Then I drew everything up and did a test carve. … Continue reading
Kyle’s Guitar – day 1
My friend Kyle recently asked if I would be interested in helping him build a custom guitar. He had some wood from his Grandfather’s farm that had been cut into … Continue reading
Midnight Woodworking 