12′ Cherry Conference room table – delivered
No rain today, so I packed up the table into my old Dodge and headed to church. I took my older son and put him and Father Jason to work, … Continue reading
12′ Cherry Conference room table – day 8
I applied the first two coats of wipe-on poly yesterday, so I added the last two coats today. Most of the surfaces were vertical, so very little dust landed on the urethane … Continue reading
12′ Cherry Conference room table – day 7
Another long day today, but I made a lot of progress. I started today by cutting away the excess trim and dowels sticking past the trim on the tops. Next … Continue reading
12′ Cherry Conference room table – day 6
The base is done, so I decided to work on making the table top today. I might be going a bit overboard, but I want the top to be strong … Continue reading
12′ Cherry Conference room table – day 5
I had a few hours to work today, so I finished up assembling the base. Since this table will have to fit into the 8′ bed of my truck, I … Continue reading
12′ Cherry Conference room table – day 4
The rails dried over night so I pulled the clamps. The first thing I did was to plane down the little shim that was filling a gap on the rails. … Continue reading
12′ Cherry Conference room table – day 3
Made a lot of progress on the table today. I have a lot of joinery on this table so I decided to try several different methods of creating my mortises … Continue reading
12′ Cherry Conference room table – day 2
Heat has been off-line, in the shop for the last week, so I haven’t been doing much down there. I had some time to trouble shoot yesterday, so the heat … Continue reading
12′ Cherry Conference room table – day 1
I started on my latest church project for St. Peter’s. A 12′ long conference table with a cherry trestle base. Conference table plan.PDF The majority of the base will be … Continue reading
Midnight Woodworking 