I have a picture of what the current altar looks like. The tabernacle sits pretty low and there is a simple panel that runs along the back side. Earlier this week, a couple of gentlemen raised the crucifix about 24″ higher so there would be room for the new back altar.
The adoring angels, on each side, sit on a stand that is a bit top-heavy and does not match the style of the altar.
When I arrived, Some fine people helped remove the back panel and tabernacle.
I installed the elevated base for the tabernacle as well as padded out the sides and placed a trim piece along the front.
Then I had help setting the heavy cabinets in place.
When the dome was placed, I could move the cabinets until everything was lined up correctly then I attached the cabinets to the altar with a few cabinet screws. I also used a couple of trim screws on each side of the dome to hold it down as well.
After the tabernacle was placed in it’s new elevated location, I could permanently affix it back to the altar with some heavy wood screws.
We then replaced the angels on their new bases.
No final decision has been made for what goes behind the tabernacle but I made two panels that can be painted or wrapped with fabric. Eventually, back-lighting may also be added.
I attached one of the panels so they have mounting holes in case they remove it to try different color schemes.
The columns, that the angels sit on, were made large enough that they could be turned in any direction without overhanging. With the heavy, thick base, they are very stable as well.
Father Jack had me remove the back panel to experiment with hanging a crimson cloth behind it which he likes a lot.
I will leave the details for them to decide…
Challenging project, The matching ambo is next.